With IPv4 I can use
I've got IPv6 configured but I can't see any IPv6 address from
asked 22 Nov '11, 15:09
On Linux the command is "ip neigh show". This will show both ARP and NPD. If you want only NPD you can add -6 to the command.
answered 28 Nov '11, 02:44
IPv6 uses Neighbor Discovery Protocol instead of ARP to associate IP addresses and MAC addresses.
On MacOS X (and other BSD based Unix systems) you can use the command
This answer is marked "community wiki".
answered 22 Nov '11, 15:14
On windows, use the following command to see the mappings,
C:>netsh interface ipv6 show neighbors
answered 25 Dec '11, 07:30
More commands available on IPv6 from the windows command prompt,
C:>netsh interface ipv6 show /?
The following commands are available:
Commands in this context:
show address - Shows IPv6 addresses.
show bindingcacheentries - Shows binding cache entries.
show destinationcache - Shows destination cache entries.
show dns - Displays the DNS server addresses.
show global - Shows global configuration parameters.
show interface - Shows interface parameters.
show joins - Shows IPv6 multicast addresses.
show mobility - Shows mobility configuration parameters.
show neighbors - Shows neighbor cache entries.
show prefixpolicy - Shows prefix policy entries.
show privacy - Shows privacy configuration parameters.
show routes - Shows route table entries.
show siteprefixes - Shows site prefix table entries.
show state - Shows the state of deprecated functionality.
show teredo - Shows Teredo service state.
answered 25 Dec '11, 07:43